Students: You will work through the following exercises during the 2 hour tutorial. Exercise 6 below is the beginning of an assignment that you will work on this week and next week.
Exercise 1: Points and Lines
Draw some points in Rhino. Assign points to grasshopper
point component. Draw lines between points with Line AB component.
Exercise 2: Slider
Draw a circle in Grasshopper. Control the radius with a
slider
Exercise 3: Division & Multiplication
Draw a rectangle in Grasshopper. Control the length of one
parallel set of edges with a slider. Set the length of the other parallel set
of edges as a ratio of the length of the slider controlled edges.
Exercise 4: Divide a Curve
Draw a curve. Divide the curve into an amount of sections
defined by a slider. Place a sphere at each division point.
Exercise 5: Loft Curves
Draw two curves in Rhino and loft them in Grasshopper. Move
the control points of these curves in Rhino and see how the loft responds.
Exercise 6: Assignment 1, part 1
Create a 3D representation of your first initial. Be
creative! J
The outcome of this exercise will be developed further in
next week’s tutorial.
Exercise 7: Play!
If you finish the other exercises, just explore and play and see what you can make in Grasshopper.
If you finish the other exercises, just explore and play and see what you can make in Grasshopper.
No comments:
Post a Comment